fluid-dynamic-bearing · shipping · also FDB, fluid film bearing, hydrodynamic bearing

Fluid dynamic bearing

A fluid dynamic bearing (FDB) carries an HDD spindle on a thin pressurised lubricant film generated by grooves, so rotor and stator do not touch while spinning.

In a 3.5-inch prototype the journal bearing is an oil-lubricated sleeve and shaft with two herringbone groove bearings on the shaft, which pump oil inward to prevent leakage in operation, while capillary sealing holds it at rest. [2] With no metal-to-metal contact the rotor rides on a liquid film, removing the forces of rolling balls. [3]

The prototype ran at 10,200 rpm with axial and radial non-repeatable runout below 0.05 µm and repeatable runout within 2.6 µm, measured without disks. An air journal bearing would need about one tenth of the oil bearing's radial clearance, 1 µm against 10 µm, for comparable stiffness and would still carry almost an order of magnitude less load. [2]

A hybrid design with an air thrust bearing cut bearing power loss by about 20% against an all-oil design, yet the spindle still drew about 30% more power than a ball-bearing reference from a high-end drive. [2] An earlier study of 5.25-inch spindles found substantially less non-repeatable runout with fluid bearings than with typical ball bearings. [4]

3.5-inch FDB motors at 7,200 rpm measured 25.0 dBA at 0.30 m and 10.3 dBA right after power was cut, so electromagnetic excitation rather than the bearing dominated the noise. [3]

Relations

related
Hard disk drive (HDD), HDD head gas bearing, Rotational vibration (RV)

Advantages

  • Better non-operational shock resistance, speed control and damping of motor structure modes are claimed over ball-bearing spindles. [2]

Limitations

  • Fully hydrodynamic bearings have relatively high power losses and are hard to seal to zero leakage. [2]
  • All-air variants offer no path to discharge static charge. [2]
  • The hybrid design carries a higher risk of thrust-bearing damage from large shocks in shipment than an all-oil design. [2]

Citations

  1. Zhang, Chen and Liu. Design of a Hybrid Fluid Bearing System for HDD Spindles. IEEE Transactions on Magnetics 35(2), 1999. (accessed 2026-10-16)
  2. Ajavakom et al. Toward a Vibro-Acoustic Analysis of FDB Spindle Motors. MIPE 2006. (accessed 2026-10-16)
  3. Bouchard, Lau and Talke. An Investigation of Non-Repeatable Spindle Runout. IEEE Transactions on Magnetics, 1987. (accessed 2026-10-16)

Further reading

  1. Fluid dynamic bearing (accessed 2026-03-26)
Sources & caveats
  • The hybrid design is a 1999 research-institute prototype, not a production drive, read through a repository copy.
  • The acoustic paper (2006) measured a small sample of identical motors, with partial support from a motor manufacturer.
  • The 1987 runout study was read in abstract only, which gives no figure.
  • No open source giving FDB versus ball-bearing lifetime or failure rates was found, so no reliability claim is made.

JSON: /data/terms/fluid-dynamic-bearing.json

Published by Hesela team · Updated

Report a correction · Editorial standards · Reuse guidance

Cite this page
Hesela team. Fluid dynamic bearing. Hesela. 2026-10-22. https://hesela.dev/terms/fluid-dynamic-bearing/