raid-10 · shipping · also RAID10, RAID 1+0

RAID 10

RAID 10 combines replicated data copies with striping across storage members.

Related Observatory article: Read on hesela.com

Conventional RAID 1+0 uses fixed mirror groups; with two members per group, every group needs a current, readable survivor. Any single member may fail, but two failures in one pair remove both copies of its data. [4] Linux MD also supports near, far and offset layouts and odd member counts, so copy placement must be checked. [2]

Hesela's fixed-pair enumeration counts failure combinations, not observed reliability or repair timing. [3] Ratios of counted subsets describe conditional probabilities only when same-size failure sets are equally likely; failure-count timing and member placement require separate evidence. [3]

RAID 0+1 mirrors complete stripe sets instead of striping over fixed mirrors. The same disk count does not make these nesting orders interchangeable. [4]

Relations

related
RAID, Mirroring (storage), Striping (storage), Mirror set, Failure domain, Degraded array, RAID 01

Limitations

  • A count of failed disks does not identify whether every required mirror retains a usable copy. [3]

Citations

  1. mdadm md(4): RAID1 and RAID10 layout (revision e5a1d3e) (accessed 2026-10-15)
  2. Hesela: RAID 10 mirror topology and exact failure-set counts (accessed 2026-10-15)
  3. SNIA Swordfish 1.2.4a: RAIDType placement definitions (accessed 2026-10-21)

Further reading

  1. RAID 10 (accessed 2026-03-26)

JSON: /data/terms/raid-10.json

Published by Hesela team · Updated

Report a correction · Editorial standards · Reuse guidance

Cite this page
Hesela team. RAID 10. Hesela. 2026-10-21. https://hesela.dev/terms/raid-10/