Helical scan recording
Helical scan recording writes short slanted tracks across slowly moving tape with heads on a rotating drum, as in DAT-family data cartridges and some video formats.
In the DDS formats for 3.81 mm tape, a pair of heads with azimuths of about +20 and -20 degrees forms the track pattern from tape motion and drum rotation. Tracks have a 9.053 um average pitch, held to +/-0.045 um over 30 tracks, a 23.521 mm length and an angle of 6 deg 22' 39.6'' to the reference edge. [2][3] The test scanner is 30.00 mm across and turns at 2000 rpm, so the heads move at about 3.14 m/s against tape speeds of 5.43 mm/s (DDS-2) and 8.15 mm/s (DDS-3). [2][3]
Density grew within the same geometry. DDS-2 records at most 2,999.9 flux transitions per mm, 70,560 bits per track, for 4 GB uncompressed on 125 m of tape, a step it attributes to 1.5 times higher track density. [2] DDS-3 doubles linear density to 5,999.7 per mm and stores 12 GB, three times DDS-2, as more of each track carries user data. Each recorded cartridge holds one format, and the standards do not require a drive to read the others. [3]
Relations
Citations
- ECMA-198: 3,81 mm Wide Magnetic Tape Cartridge for Information Interchange - Helical Scan Recording - DDS-2 Format using 120 m Length Tapes
- ECMA-236: 3,81 mm Wide Magnetic Tape Cartridge for Information Interchange - Helical Scan Recording - DDS-3 Format using 125 m Length Tapes
Further reading
Sources & caveats
- c2 (ECMA-198, 1995) and c3 (ECMA-236, 1996) cover the DDS family only; 8 mm formats and earlier DDS editions were not consulted in full, one scan not being extractable.
- Scanner diameter, speed and tension are test conditions for signal measurement, not a drive design.
- The title of c2 says 120 m tapes while its foreword gives 4 GB on 125 m.
- No cited source compares helical scan with linear tape.
- Arithmetic: pi x 0.030 m x 2000 / 60 = 3.14 m/s, about 580 x 5.43 mm/s and 385 x 8.15 mm/s; 23.521 mm / 0.1666 um = 141,000 bit cells.