holographic-storage · research · also volume holographic storage

Holographic data storage

Holographic data storage records pages of bits as interference patterns of a data beam and a reference beam in a photosensitive medium, with many holograms sharing one volume.

Related Observatory article: Read on hesela.com

One coherent beam carries a two-dimensional page of up to about a million bits from a spatial light modulator and the other is a plane-wave reference that indexes the page; because the medium is thick, several thousand holograms can share a volume by changing angle, wavelength or shift between recordings. [2] Thin organic media suit rotating disks, thick photorefractive crystals angular multiplexing. [2]

With a linear medium the dynamic range per hologram is roughly the total divided by the number of holograms N, so readout signal falls as 1/N^2, signal-to-noise ratio falls with capacity and raw bit-error rate rises; integration time can compensate only at the expense of data rate. [2] A rotating photopolymer disk demonstration read pages of about one megabit at 6 kHz, 6 Gb/s, with a raw error rate of about 0.8 percent that Reed-Solomon coding can correct, at about 5 bits per square micrometre. [2] Arithmetic: doubling N cuts per-hologram signal to a quarter, 6 dB; 1024 x 1024 pixels x 6000 pages/s is 6.29 Gb/s.

ECMA-377 (2007) specifies a 120 mm write-once cartridge of 200 GB with data holograms at 532.0 nm, a separate 655 nm beam for tracking, a 358 x 358 modulator with a 192 x 192 data page, a 300 rpm disk, and 208 pages of 1632 bytes per 188 user packets after Reed-Solomon parity. A finalizing step fixes the disk, which is operated at 35 +/- 2 degrees Celsius before it. [3]

Relations

related
Optical archival storage, Write-once media, CD block error rate (BLER), Reed–Solomon codes (storage), Magneto-optical disc

Limitations

  • Readout light erases the stored space-charge pattern in photorefractive crystals unless the hologram is fixed, for example by raising temperature during recording. [2]
  • The 2000 demonstration needed positioning repeatability better than 0.1 micrometre, and the standard prescribes micrometre-scale modulator and detector geometry. [2][3]

Citations

  1. Volume Holographic Data Storage, S. S. Orlov, Communications of the ACM, November 2000 (accessed 2026-10-16)
  2. ECMA-377: Information Interchange on Holographic Versatile Disc (HVD) Recordable Cartridges, 200 Gbytes per Cartridge, May 2007 (Ecma) (accessed 2026-10-16)

Further reading

  1. Holographic data storage (accessed 2026-03-26)
Sources & caveats
  • The review is a 2000 university review written around two research consortia funded by a US defence research agency; the standard is from 2007; neither shows that a product exists, and no cost, price or market claim is made.
  • ECMA-377 was proposed by an alliance of companies, so it is not wholly vendor-independent; the review is the independent source.
  • The ACM Transactions on Storage article on holographic storage for the cloud returned an access-denied error and was not read.
  • Arithmetic: 192 x 192 = 36,864 pixels is 28.8 percent of the 128,164 modulator elements; user bytes are 192,512 / (208 x 1632) = 56.7 percent of data-page content after parity.
  • Arithmetic: 1024 x 1024 = 1,048,576 pixels per page, x 6000 pages/s = 6.29 Gb/s of channel data, consistent with the 6 Gb/s quoted; the standard gives 200 GB as nominal capacity and none is derived here.

JSON: /data/terms/holographic-storage.json

Published by Hesela team · Updated

Report a correction · Editorial standards · Reuse guidance

Cite this page
Hesela team. Holographic data storage. Hesela. 2026-10-16. https://hesela.dev/terms/holographic-storage/