initiator-target · shipping

SCSI initiator and target

A SCSI initiator issues commands to logical units served by a SCSI target.

Related Observatory article: Read on hesela.com

Roles and ports: A target can contain several logical units and have several target ports. SCSI port identity is transport-specific; in iSCSI it is not simply a physical network socket. [3]

Error handling: iSCSI requires autosense: CHECK CONDITION responses include sense data. BUSY and TASK SET FULL are different statuses and do not imply sense data. [3]

Relations

related
SCSI, SAN, iSCSI, Serial Attached SCSI (SAS), Fibre Channel, Host bus adapter (HBA), Multipath I/O, INCITS T10 SCSI, RDMA storage networking, Logical unit number (LUN), Command descriptor block (CDB), SCSI CHECK CONDITION, SCSI logical unit (LU), iSCSI autosense

Citations

  1. RFC 7143: SCSI ports, autosense and status (sections 4.4.2, 10.2, 11.4.2 and 11.4.7) (accessed 2026-10-20)

Further reading

  1. SCSI initiator and target (Wikipedia) (accessed 2026-10-11)
  2. SCSI (Wikipedia), sections on the SCSI command protocol, parallel interface and general addressing (accessed 2026-10-11)
Sources & caveats
  • Port mapping and mandatory autosense are described for iSCSI by RFC 7143; other transports have their own mappings and recovery rules.

JSON: /data/terms/initiator-target.json

Published by Hesela team · Updated

Report a correction · Editorial standards · Reuse guidance

Cite this page
Hesela team. SCSI initiator and target. Hesela. 2026-10-20. https://hesela.dev/terms/initiator-target/