PATA
Parallel ATA (PATA) is the parallel form of the ATA storage interface, traditionally allowing two devices to share a channel.
Identity: PATA and IDE overlap in naming; they are not consecutive interface generations. A SATA controller's IDE-compatible programming mode is also distinct from its physical serial link. [4]
Connections: A desktop 40-pin data connector can use an 80-conductor cable: the extra conductors improve grounding rather than double the data-bus width. Ultra ATA/66 needs compatible host, drive and cable support. A documented notebook variant uses a 44-pin connector that also carries power, so 40 pins are not universal. [5] [6]
Transfer modes: Early PIO timings do not bound later PATA. Documented examples include Ultra DMA mode 4 at 66.6 MB/s, mode 5 at 100 MB/s and mode 6 at 133 MB/s. These are interface limits, not guaranteed sustained media or application rates. [8] [6] [7]
Shared channel: Device selection uses configuration such as jumpers or cable select. Two attached drives share the host channel; their presence does not establish two independent full-rate paths. [2] [4]
Relations
- related
- Serial ATA (SATA), Hard disk drive (HDD), AHCI, ST-412, IDE / ATA, Ultra DMA
- superseded by
- Serial ATA (SATA)
Advantages
- Software written for the parallel register model could carry over to the serial successor. [3]
Limitations
- Each drive on a shared cable needs jumper, switch or cable-select configuration. [2]
Citations
- X3T10 791D revision 4c. AT Attachment Interface for Disk Drives (ATA-1 working draft), 1994.
- Serial ATA Working Group. Serial ATA: High Speed Serialized AT Attachment, Revision 1.0, 29 August 2001.
- UEFI PI 1.8: IDE controller terminology, sections 7.2.1.1 and 7.2.3.1
- Western Digital: Ultra ATA/66 FAQ, April 1999, questions 2-7
- Seagate: Momentus 7200.1 PATA Product Manual, Rev. C, August 2007, sections 2.5 and 4.1
- Maxtor: DiamondMax16 Product Manual, 16 October 2003, sections 5.2.1 and 5.3.1.1
- Seagate: Barracuda ATA II Product Manual, Rev. A, February 2000, introduction and section 2.2.4
Further reading
Sources & caveats
- The retained 1994 firstSeen value denotes the ATA-1 standardization context, not invention, first shipment or the first use of the PATA name.
- Connector and transfer-mode examples come from particular historical products, not a claim that all PATA devices implement the same modes.
- The rate figures retain the rounding used in the manuals and are not measurements performed by Hesela.
- Historical interface documentation does not establish a single current end-of-life status for all implementations.