st-412 · end of life

ST-412

Seagate's follow-on full-height 5.25-inch HDD interface companion to the ST-506 ecosystem.

The ST-506 was Seagate's 1980 5.25-inch drive and the first of its size; the ST-412 followed in late 1981 as a 10 MB drive with 306 cylinders and buffered seek, and the two names later came to denote one disk interface, ST-506/ST-412, which numerous manufacturers adopted as a de facto standard well into the 1990s. The interface descends from the Shugart SA1000 interface, itself based on the floppy disk interface: a 34-pin control cable that can serve four drives, plus a 20-pin data cable per drive carrying separate Read and Write differential pairs, and a four-pin power connector. The controller card, not the drive, does the work: it translates host requests into head-positioning commands, sends STEP pulses, and handles MFM encoding, which gives one data bit per transition at 5 Mbit/s. The ST-412HP extension used RLL encoding, averaging 1.5 data bits per transition for 7.5 Mbit/s and about 50% more capacity. Limits of the interface are 5 million transitions per second on the data lines, 16 heads, 4 drive units and a 20-foot (6.1 m) cable. Buffered seek let the controller send STEP pulses as fast as the drive could accept them, cutting average seek from about 170 ms on the ST-506 to about 85 ms; by the late 1980s drives with this interface reached 15 to 30 ms. The interface was picked for the original IBM XT, and was gradually replaced by SCSI and ATA (IDE), which moved the controller into the drive. Wikipedia lists a few early SCSI and IDE drives that were simply an ST-412-interface drive with a controller board attached.

Relations

related
ST-506 interface, Hard disk drive (HDD), IDE / ATA, PATA, SCSI, ESDI, Floppy disk, Seek time

Advantages

  • Separate controller and drive meant a failed controller could be replaced without losing the data, and the raw analog read signals were available for specialist data recovery
  • Derived from the floppy interface, so controller design was relatively easy and many vendors adopted it
  • Widely supported: it served as the de facto PC hard disk interface until IDE/ATA spread in the early 1990s

Limitations

  • At most 4 drive units per control cable and 16 heads, with a cable limited to 20 feet (6.1 m)
  • Data rate capped at 5 Mbit/s with MFM (7.5 Mbit/s with the ST-412HP RLL variant), since the interface allows at most 5 million transitions per second
  • The unshielded cable could be susceptible to noise, and most controllers supported only two drives
  • Head selection, stepping and encoding sat on the controller, so the host side was complex; this drove the move to SCSI and IDE, where the controller sits in the drive

Citations

  1. ST-506/ST-412 (Wikipedia; the ST-412 page redirects here) (accessed 2026-10-10)

JSON: /data/terms/st-412.json

Published by Hesela team

Report a correction · Editorial standards · Reuse guidance

Cite this page
Hesela team. ST-412. Hesela. https://hesela.dev/terms/st-412/