ESDI
ESDI (Enhanced Small Device Interface, X3.170-90) is a disk interface with a daisy-chained serial control cable for up to seven drives and a radial data cable per drive.
The standard was published as X3.170-90 [3]. In its 1987 draft the control cable runs through up to seven devices and is terminated at the last, while each data cable runs directly to the controller with differential pairs for data and clocks, on a 34-pin J1 and a 20-pin J2 connector. The interface handles 0 to 24 Mbit/s, with clocks of 0 to 15 MHz on a low-speed port and 10 to 24 MHz on a high-speed one, and each drive reports its rate class. Magnetic disks pass NRZ data, and drives may be fixed-sector or soft-sector. [2]
Commands travel as 16-bit words plus odd parity with a 4-bit function code, allowing 16 functions, among them seek, recalibrate, status and configuration requests and optional head-group, offset, diagnostic and sector-size settings. Seek carries a 12-bit cylinder field, so 4,096 cylinders are directly addressable. An optical-disk command set adds Format so that magnetic-disk controllers could support optical drives. [2]
One open-source adapter driver addresses disks by cylinder, head and sector and reads a configuration reply with block count, cylinders, sectors per track, heads and flags for defects, skew, removable media and retries. [4]
Relations
- related
- ST-506 interface, SCSI, IDE / ATA, ST-412, PATA
Citations
- Enhanced Small Device Interface, X3T9.3/87-005 Rev 2 working draft
- ESDI X3.170-90 Interface Specification
- drivers/block/ps2esdi.c, Linux kernel 2.6.20 source
Further reading
Sources & caveats
- Details follow working draft X3T9.3/87-005 rev 2 (16 October 1987), machine-read; draft and final 1990 standard were not compared.
- c3 is a scan of X3.170-90 distributed by Micropolis and hosted on bitsavers.org; only its title page was checked, as it has no text layer.
- The standard documents say Enhanced Small Device Interface; the alias Enhanced Small Disk Interface follows c1.
- That NRZ data places encoding in the drive is an inference; c2 does not state it as a goal.
- c4 is the Linux 2.6.20 driver for one adapter, not the drive cable interface.
- Arithmetic: 2^12 = 4,096 cylinders; 2^4 = 16 function codes.