IBM RAMAC
IBM RAMAC is the 305 accounting system introduced in 1956, whose IBM 350 unit provided moving-head magnetic disk storage for five million alphanumeric characters.
Geometry: 50 disks x two recording sides x 100 tracks = 10,000 tracks; at 500 characters per track, capacity is five million characters. The operating manual also specifies 50,000 sectors of 100 characters. [4][5]
Coding: two zone bits and four numerical bits carry the character; a check bit supplies odd parity. The design paper counts eight recorded positions, including a space bit used by its self-clocking system. Thus six data bits, seven data-plus-check bits and eight recorded positions describe different boundaries. Five million x 6 / 8 = 3.75 million octets of data-bit equivalence, not a modern byte-addressed interface. [4][5]
Mechanism: two heads straddle a selected disk. Compressed-air jets maintain head spacing, and the arms retract before vertical carriage movement. There is not one fixed head per recording surface. [4]
Verification: a written disk record is automatically read back and compared against the sending record; a mismatch stops the machine and lights the file-error indicator. Immediate readback is separate from parity checking and does not establish long-term retention. [5]
Timing: the design paper reports about 0.5 s average and 0.75 s maximum access; the 1984 brochure gives 0.6 s average. These are differently sourced specifications, not observations from one measured distribution. [2][4]
Addressing: The manual's programmed-addressing example groups ten 100-character sectors into each of 5,000 track-address groups. This grouping is not the paper's count of individual surface tracks. Application records can span sectors, and calculated addresses may collide, requiring overflow handling. [5]
Layout: In the indexed example, one sector indexes nine others; load active records first to limit overflow seeks. [5]
Relations
- related
- Hard disk drive (HDD), Drum memory, HDD head gas bearing, Seek time, Areal density, Winchester disk architecture
- superseded by
- Hard disk drive (HDD)
Advantages
- Moving heads address 10,000 recording tracks across the disk stack; records need not be reached by reading all preceding records on a tape. [4]
- Established the air-bearing, moving-head disk concept (heads floating on air about 800 microinches above the surface) that later disk drives refined. [1, 2]
Limitations
- Very low density and size: 2,000 bits per square inch, 24-inch disks and a unit over one ton including its air compressor. [1, 2]
- Slow by later standards: about 600 ms average access and 100,000 bits per second, against 16 ms and 24 million bits per second for the 1984 comparison file. [2]
Citations
- Computer History Museum — 1956: First commercial hard disk drive shipped (The Storage Engine, IBM Model 350 RAMAC)
- The IBM 350 RAMAC Disk File (ASME International Historic Landmark brochure, 1984; prepared with the maker's staff assistance)
- Noyes and Dickinson: The Magnetic-Disk, Random-Access Memory, IBM J. Res. Dev. 1(1), 72-75 (1957); DOI 10.1147/rd.11.0072
- IBM 305 RAMAC Manual of Operation, Form 22-6264-1 (April 1957), pp. 61-64, 70-73 and 82